Water Treatment Market

Know Your Water. Hire Verified. Buy Right.

New Port Richey's Water, In Plain Words

Inside the city, New Port Richey is the exception in this part of Pasco: it runs its own wells and its own treatment plant, and publishes its own report. This is that report.

← All water quality pages
The honest headline: this system meets current legal standards on its compliance averages — the city's own report states plainly that its drinking water meets all federal and state requirements, and no utility on this site is "breaking the law" with its water. What its own report documents is below: the levels it actually measured, next to the legal limits. And the boundary matters here: these are the city system's numbers, for city-system homes. A New Port Richey mailing address outside the city's service area can be on Pasco County Utilities' regional system instead — a different system with different numbers, read on the Wesley Chapel and Land O' Lakes pages — and coastal homes on private wells have no report at all. Your bill names your utility.

Who actually serves New Port Richey — and how we know

The City of New Port Richey publishes its own Annual Drinking Water Quality Report under its own system number (Public Water System 6511255) — a city system, not a county one. Its report describes its primary source as groundwater from a combination of 10 wells drawing from the Floridan Aquifer (the underground limestone formation under most of Florida), treated at the city's William C. Maytum Water Treatment Plant. The Tampa Bay Water regional system is listed as another available source. Homes outside the city's service area with a New Port Richey address are commonly on Pasco County Utilities instead, and some coastal homes are on private wells — see the private wells page if you have no water bill. Just south across the county line, the water changes again — see the Tarpon Springs page.

Where the water comes from — and what the plant does to it

Rain percolates through sand, clay, and limestone into the Floridan Aquifer; the city's 10 wells draw it back up. At the Maytum plant, the treatment steps the city's report names are specific to well water like this: aeration to remove hydrogen sulfide (the rotten-egg gas that raw Florida well water commonly carries — the city strips it at the plant, before it reaches your tap), chloramination for disinfection (chlorine combined with ammonia — it lasts longer in pipes than plain chlorine, does not evaporate out of a pitcher, and needs catalytic carbon to remove), and fluoride, which the city added for dental health until it discontinued the addition on June 30, 2025. The Florida Department of Environmental Protection's 2025 source water assessment for the city system identified one low-level potential source of contamination near its wells.

What the report measured

Measure (what it is)ResultLegal limitHow to read it
Copper, 90th percentile of home samples (9 of 10 homes at or below; sampled January–March 2025)1.273 parts per million, with 3 sampled homes over the action level1.3 parts per million action level98% of the action level — the closest any system on this site runs to its lead-and-copper trigger. The system itself is not in violation (the trigger is the 90th percentile, and it stayed under), but 3 individual homes tested over it, and copper comes from the home's own plumbing: this is the strongest documented case on this site for testing your own tap
Lead, 90th percentile of home samples (January–March 2025)1.28 parts per billion, with no sampled homes over the action level15 parts per billion action levelWell under — the copper story here is not a lead story, and the page keeps them separate
Disinfectant: chlorine and chloramines, highest running annual average (individual samples ranged 0.6–4.0)2.8 parts per million4.0 parts per million70% of the legal cap — lower than the county and Pinellas systems, still chloramine, with the same taste and resin-wear facts
Disinfection byproducts: total trihalomethanes (chemicals that form when disinfectant reacts with natural matter in the water), highest running annual average31.79 parts per billion80 parts per billionAbout 40% of the limit
Disinfection byproducts: haloacetic acids, highest running annual average21.75 parts per billion60 parts per billionAbout 36% of the limit
Fluoride (sampled January–June 2025)0.72 parts per million in the 2025 report; the city discontinued adding fluoride on June 30, 20254.0 parts per millionThe 2025 figure is from the months when the city was still adding it; expect a lower, natural-only level going forward
Sodium11.8 parts per million160 parts per million standardLow — notably lower than the brackish-source systems on this site, despite the coastal address
Nitrate (as nitrogen)0.12 parts per million10 parts per millionVery low
PFAS ("forever chemicals"), federal monitoring under the Fifth Unregulated Contaminant Monitoring RuleNone of the contaminants tested for in the study were detected, the city's report states4.0 parts per trillion each for the two main compounds (2024 standards)The city's own monitoring statement, in its own words — reported here as the report states it, at the study's reporting levels
Hardness (the minerals that build scale)Not published in the city's reportNo legal limitAn honest gap, stated rather than filled: the city report prints no hardness figure, so any New Port Richey hardness claim should come from a test at your home, not a document

Source: City of New Port Richey 2025 Annual Drinking Water Quality Report (Public Water System 6511255; monitoring year 2025), read directly, in full, in this pass.

What it means for your home

Thinking about treatment? Find a verified provider — and ask any provider to test your water at your tap, because your home's own plumbing is part of the picture.