Water Treatment Market

Know Your Water. Hire Verified. Buy Right.

Hankscraft REV 2.5 Owner Guide

The REV4's little brother kept the same bypass. Learn it once and you know it on both valves.

A Hankscraft push-pull bypass fitting
Image: a Hankscraft push-pull bypass. Illustrative only — never evidence for a claim, a listed business's work, a product, or a measurement. Source: Aqua Pro Services photo library, on file.
← Maintenance & Care
Key point: Hankscraft did not change the bypass between the REV 2.5 and the REV4: both manuals document the same Ceramic Bypass 41206/41207 in the same section — section 6.

1. The bypass — same part, same section

2. Clock and settings

Programming lives in section 7 of the RevV2.5 manual (the book on file is revision 1, dated February 1, 2020). The owner-level items are the clock and the regeneration schedule: a wrong clock after an outage means regeneration in your morning shower instead of at 2:00 a.m. The hardness number tells the valve how often your water needs it to regenerate; it was set from your water test at install — city water here runs about 14 grains, wells are all over the map. A couple of grains either way is the safe band. Your numbers are on the settings card at your unit; trust the card over anything on a forum, because the forum does not know your tank or your well.

3. Salt

Pellets, tank covered, checked monthly, salt above the water line. A tank that looks full while the water goes hard is the classic salt bridge — a hollow crust over empty space, common in humid garages — so poke it gently with a broom handle before blaming the valve. And on a sulfur setup, a returning rotten-egg smell is a system service call, not a cue to start changing valve settings.

Sources

Keep going